Once a key is free, someone can legitimately create a new access with it. The
forced revocation looked the key up and would have deleted that person's access
and pulled their key off the hub. It now acts only on an adoption artifact — a
system peer with no owner and no creator — and leaves anything else alone.
Re-issuing also threw when VPN_CONFIG_KEY was missing, which is exactly the
situation the console tells people to fix by re-issuing. It now hands the new
config over once instead of storing it.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
Codex found that a sync landing between the key swap and its removal would see
the old key as unknown. Writing the test showed something worse than the
duplicate he predicted: the adoption cannot even happen — the address still
belongs to the live access — so the insert violated the unique index and took
the ENTIRE reconciliation down with it. One stale key would have stopped every
peer's state from updating.
The sync now recognises that case and queues the removal instead of adopting,
and a key with no row of its own is revoked with force: it can only ever be
removed, never kept, so the removal cannot be talked out of it by a row that
should not exist.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
A sync could read the hub snapshot just before ApplyVpnPeer removed a peer and
purged its tombstone, then adopt what it had seen as a fresh enabled access —
restoring a revoked one. Both jobs now hold Cache::lock('wireguard:hub') around
read-decide-mutate, so a reconciliation can never straddle a removal. Retry
removals are dispatched after the lock is released, because the sync queue
driver runs them inline and they take the same lock.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
If an add job was retried after the access had been revoked and its tombstone
purged, it found no row and trusted its own enabled=true payload — re-adding a
key that no longer had a row anyone could revoke it with. A missing row can only
mean the access is gone, so the captured payload may now remove but never
enable.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
Two lifecycle holes Codex found in the new VPN management:
1. Delete removed the row before the hub knew. If the removal job was delayed
or failed, SyncVpnPeers saw a peer it did not recognise and adopted it back
as a live access — silently restoring what an operator had just revoked, and
with no row left to revoke it again. Deletion is now a soft-delete
tombstone: the row survives until the hub confirms the peer is gone, the
sync retries the removal instead of adopting, and the tombstone is purged
only once the peer is really absent. It also keeps the key and the tunnel
address reserved meanwhile, so neither is handed out twice.
2. ApplyVpnPeer applied the state captured at dispatch. A retried block job
could therefore undo a later unblock, and nothing would repair it — the sync
only observes state, it never re-applies intent. The job now resolves the
current desired state from the row and treats its payload as a fallback for
the case where the row is already gone.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
The console can now create, block and remove VPN accesses, and shows who is
actually connected — traffic counters, source endpoint and last handshake.
Design notes:
- The web container has no wg0, so the page never talks to WireGuard. Live
state is copied in by SyncVpnPeers on the provisioning queue (the only worker
whose container owns the interface); the page polls the database and merely
nudges that job, throttled so many open tabs cannot flood the queue.
- enabled (operator intent) and present (observed on the hub) are stored
separately, so a sync can never quietly undo a block and drift stays visible
as "wird angewendet".
- The sync adopts peers the host pipeline registered, naming them after their
host — otherwise "who is on the VPN" would have blind spots.
- Keypairs are generated in PHP via libsodium rather than shelling out to
wg genkey (no interface in this container, and it keeps generation testable).
The private key is shown once and never stored.
- allocateIp() now also considers vpn_peers, which would otherwise be handed a
tunnel address a host already holds.
- vpn.manage is a new capability held by Owner/Admin only, and it hides the nav
entry too — a VPN access reaches the management network.
Verified end to end against the real hub, not just mocks: created an access in
the browser, connected with the generated config, watched the console flip to
"Verbunden" with real counters, then blocked it and confirmed the peer was
gone from wg0 and the client could no longer handshake.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
nexxo